All about the software

Minitiouner v2 failing all tests.

Postby G8EEY » Wed 26 Feb 2020 16:04

I have just built a Minitiouner v2 using board, NIM and USB minimodule from BATC, 10K resistor added to USB module. All voltages are within spec and current is around 300mA.
I allowed a windows 10 laptop to setup usb drivers and powered up the Minitiouner. Running TestMyMinitiouner (latest) fails completely. Am I looking for hardware or software failure?

Mini Test gives:

D2XX test -OK Device Present... NIM : ?????
___________________________________________
DLL version: 3.2.14
we have found 2 device (s)
.............................................................
device 0:
device named: FT2232H MiniModule A
..............................................................
device 1:
device named: FT2232H MiniModule B
>>>>>>>>>> NO MiniTiouner connected to USB MASTER!
<<<<<<<<<<<
>>>>>>>>>> NO MiniTiouner-Pro connected to USB AUX!
<<<<<<<<<<<
_________________________________________________
________
G8EEY
 
Posts: 1
Joined: 23 Feb 2020

Re: Minitiouner v2 failing all tests.

Postby G8EEY » Sat 29 Feb 2020 16:25

Problem solved, the BATC supplied FT2232H usb mini module did not seem to be pre-programmed as expected.
Mike.
G8EEY
 
Posts: 1
Joined: 23 Feb 2020

Forum Statistics

Who is online

Users browsing this forum: No registered users and 2 guests

Options

Return to Minitioune