Hello dear OM 4Z1ZV. I've just finished to print the case !
It s almost perfect, but I was forced to remove the two beads from the 2 holes of the NIM, otherwise the card did not fit in the case correctly.
I think this problem is due to type of NIM used.
If you have the possibility to remove theses 2 beads on each F plug (inside the panel), I think it could be ok for all NIMS.
Maybe there is enough space to add the lcd display ?
Thank you so much for this case, minitiouner pro is correctly protected !
Best regards
73 QRO F8BUU Patrice
![Très content :D](./images/smilies/icon_e_biggrin.gif)