Fabriquez ou achetez tout fait un double tuner USB 144MHz-2450MHz avec très bas débit possible
Schéma - Test - modifications - problèmes rencontrés

3D Printer case for MiniTiounerPro V2

Postby 4Z1ZV » Sat 23 Nov 2019 21:55

Uploaded today:

[url]QO-100 MiniTiounerPro V2 Case by 4Z1ZV - Thingiverse https://www.thingiverse.com/thing:3996213[/url]
Zvika 4Z1ZV
Posts: 6
Joined: 21 Nov 2019

Re: 3D Printer case for MiniTiounerPro V2

Postby f8buu » Sun 15 Dec 2019 16:20

Hello dear OM 4Z1ZV. I've just finished to print the case !
It s almost perfect, but I was forced to remove the two beads from the 2 holes of the NIM, otherwise the card did not fit in the case correctly.
I think this problem is due to type of NIM used.
If you have the possibility to remove theses 2 beads on each F plug (inside the panel), I think it could be ok for all NIMS.
Maybe there is enough space to add the lcd display ?
Thank you so much for this case, minitiouner pro is correctly protected !

Best regards
73 QRO F8BUU Patrice :D
Posts: 1
Joined: 06 Oct 2016

Forum Statistics

Who is online

Users browsing this forum: No registered users and 2 guests


Return to MiniTiounerPro