TS selection and 22kHz lock signal and screen format on pow
Posté: Jeu 3 Aoû 2017 17:38
Another little problem.
I'm trying to get the 22kHz TS lock signal to work as the same time as the video being decoded.
If I set TS=2 and 22khz_switch=2, I get video displayed but no 22KHz lock signal output
but if I set TS=1 then I get 22KHz lock signal but no video.
Any idea what I'm doing wrong ?
Also is there any way to set the screen format on power up ?
I'm building this rx for a repeater and would like it to boot up in non expert mode, full screen with just the status constellation info across the bottom.
73 Tim
I'm trying to get the 22kHz TS lock signal to work as the same time as the video being decoded.
If I set TS=2 and 22khz_switch=2, I get video displayed but no 22KHz lock signal output
but if I set TS=1 then I get 22KHz lock signal but no video.
Any idea what I'm doing wrong ?
Also is there any way to set the screen format on power up ?
I'm building this rx for a repeater and would like it to boot up in non expert mode, full screen with just the status constellation info across the bottom.
73 Tim