Hi all.
I have MiniTiouner (FT2232 + NIM) but with Minitioune v04c do not decode Mpeg2 DVBS signal. I checked install drivers and SW on three different PCs with the same result.
On one of pc is instaled TechnoTrend S2-3200 card and Tutioune 3200 v0.2b and decoding is OK. I presume that there is installed correct video filters and codecs. But Minitiouner do not decode video.
For testing I use Raspberry Pi with RpiDatv SW and IQmodulator from PA0RJV.
Correctly decoded signal on TTS2-3200
The same test signal and the same PC, but different SW and Minitiouner.
TestMyMiniTiouner_v1_3a says the following:
DLL version: 3.2.7
we have found 2 device(s)
............................................
device 0:
device named: USB <-> NIM tuner A
For I2C, we will use this device
FT2232H I2C is open
Handle: 11025936
............................................
device 1:
device named: USB <-> NIM tuner B
For TS, we will use this device
FT2232H FIFO open for TS
Handle: 11018416
FT2232H FIFO closed for TS
............................................
USB driver version: 2.8.24
==========================================================================
------ IP and UDP detection ------
IP n° 1 = 10.57.66.52
UDP address : 127.0.0.1 port : 1234 using IP interface : 127.0.0.1
==========================================================================
****************** I2C controler INIT *******************
I2C controler INIT OK
OK MPSSE is empty
Init MPSSE I2C done!
***********************************************************
Trying to get the Demodulator serial number
we get the value = 32
Demodulator is a STV0903
NIM is a Samsung/Sharp or LG
-------------------------------------------------------------------------
trying to write $5A=90 in register X
writing $5A at address X seems OK
trying to read 1000 times register X
time to do it : 1328msec
we have : 0 reading errors from 1000
test: 512 writing/reading the Demodulator
we have : 0 writing errors and 0 reading errors from 512
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
STV0903 Demodulator setup for DVBS
----------------------------------------------------------------------
Writing demodulator default values ==> OK
time to do it: 860msec
STV0903 Init OK
writing $5A at address X seems OK
we try to do 1000 readings of register X after demodulator init
time to do it : 1812msec
we have : 0 reading errors from 1000
test: 512 writing/reading the Demodulator after initialization
we have : 0 writing errors and 0 reading errors from 512
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Init ZeroTuner Sharp/Samsung
----------------------------------------------------------------------
ZeroTuner initialization ==> OK
Reading values in STV6110 registers
Reading STV6110 is OK
FT2232H FIFO open for TS
Done ...I=0 FT_Q_Bytes= 0
Done ...I=0 FT_Q_Bytes= 0
FT2232H FIFO closed for TS
FT2232H I2C is closed
Anyone have any idea what is wrong??
How can I verify that the data from NIM pass through the FIFO to USB port and to SW decoder??
Many thanks for your cooperation.
Vy 73!
OK2UUJ Leo